You Can Repair Your Canon SD Series Lens Barrier Covers Yourself!
Many people have asked about repairing their front covers/flaps on their Canon PowerShot SD series cameras, so I’ve written up some instructions. The barrier kit on most Canon PowerShot SD series cameras is a little tricky but not impossible to replace yourself. You will need patience, a good eye and a steady hand as well as a small screwdriver. We use dental picks, they work great!
To get things started, turn on the camera to extend the lens and then open the battery door and remove the battery so that the lens stays out. This allows you to easily work on the lens barrier assembly.
First the part we need is the ‘barrel drive ring’, it’s the ring with the small piece that sticks down into the lens. Most cameras have a drive ring, but some do not. If you don’t see one in your kit then your camera does not need one. Make sure it rotates slightly once it has been inserted, otherwise it’s not in properly and can jam the lens.
Next are the springs and flaps. There is a small little tab that holds the spring in place when you put it on the ‘flap’ or ‘barrier plate’ as they are actually called. They are TINY, they are hard to hold and if you drop it… lets just say DON’T drop it on the carpet, ok? If you do lose some springs, we have them available on their own in our store for you to purchase.
Carefully put the cover or ‘flap’ in the hole with the spring pointing towards the post where the other end will connect, and then with something with a tiny and pointy tip (we use dental picks!) gently grab the loop of the spring and stick it on its post.
If you do this with the lens covers or ‘flaps’ in the open position they will stay in place once you get them properly seated. If everything pops off, just start again. Try not to stretch out the springs, they need to remain tight for the assembly to work properly.
Then gently put on the barrier cover, it’s a flat plastic ring. The tabs on the outer barrier cover match up with small slots in the lens housing and it will lock into place. Be gentle, don’t force anything too hard or you will break it and the parts will not hold it place.
Now you may test your repair prowess! Put in the battery (cross your fingers) and press the power button! Did it work? Did it go flying across the room with a cute little *SPROING!* and all the parts flew across the room? Yeah I hope not, but I’ve been there myself so you’re not alone.
Once you have it working smoothly …you’re almost done with your first digital camera repair!
Next put the dual sided tape on the barrier cover. CAUTION: Make sure to take the tape off of the backing paper but DON’T remove the paper that matches the shape of the tape on the other side!! If you take off the small paper part it will ruin the tape because it will fold and stick to itself. Bye bye tape!
The tabs of the tape fold over the edges, if they stick out the lens cover will not fit properly and can jam up the lens. Line up the tape tabs, starting at the 11 o’clock position and then fold down the tabs and press them in.
Now put on your chrome or black lens cap, line up the cap with the small indentation at the bottom, you’ll see how it goes on easily.
Fire up the camera again and admire your handywork! Good for you! You now know how easy… and yet still hard Canon digital camera repair can be, and the “Geek Squad” said that it was either unfixable or would be two hundred dollars and take several weeks to complete. Whatever Geek Squad… Whatever.
Hmm… I think I’m seeing the beginning of something big here; truely affordable Canon digital camera repair
Related posts:
Filed under Amateur Photographer, Photography by JamesJ
